Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving all of Connecticut

Overhead Door Garage Door Cable Repair in Connecticut

Frayed, snapped or slipped lift cables replaced and the door re-leveled. Typical cost $150-$350.

When your door needs Overhead Door garage door cable repair, you want it done safely and right the first time. Typical jobs in Connecticut cost $150-$350, and you approve the price first. Frayed, snapped or slipped lift cables replaced and the door re-leveled. Whether your Overhead Door garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing. Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for Overhead Door garage door cable repair

  • A cable hanging loose or off its drum
  • The door is crooked, with one side higher than the other
  • Frayed or rusty strands near the bottom bracket
  • The door stopped suddenly and won't move

Common causes

  • Rust and wear at the bottom bracket, where cables sit near wet ground
  • A broken spring that let the cable go slack and unwind
  • Drums that have slipped on the shaft
  • The door hitting an obstruction while closing

What you can check yourself

  • Don't operate the door if a cable is loose. It can come off its tracks.
  • Look at both bottom corners for frayed or rusted cable.
  • Never loosen the bottom brackets, because they are under full spring tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Secure the door and remove spring tension
  2. Replace both lift cables so they wear evenly
  3. Re-seat the cables on the drums and set them to equal tension
  4. Inspect the bottom brackets, drums and springs
  5. Level and balance the door and test it

How much does Overhead Door garage door cable repair cost?

$150-$350Typical range, parts & labor
1-1.5 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Overhead Door services

Overhead Door Garage Door Cable Repair in Connecticut

With large seasonal temperature swings in Connecticut, track brackets and hinge screws work loose over time, and a loose track is the most common reason a door rubs, binds or comes off its rollers.

Close to the coast, salt air speeds up corrosion. Galvanized or coated springs, nylon rollers and stainless hardware hold up better than bare steel.

We cover 155 cities and towns across Connecticut. Find Overhead Door garage door cable repair in your city:

Overhead Door Garage Door Cable Repair: frequently asked questions

How much does Overhead Door garage door cable repair cost in Connecticut?

Overhead Door Garage Door Cable Repair typically costs $150-$350 including parts and labor, and usually takes 1-1.5 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Overhead Door garage door cable repair the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Overhead Door garage door cable repair covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Overhead Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Connecticut or your city requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Connecticut

Moore-O-Matic Remote & Keypad Programming

Moore-O-Matic openers are no longer made. We can often keep one running with available parts, or recommend a modern replacement.

Typical $50-$150

Clopay Garage Door Panel Replacement

Clopay is one of the largest residential garage door makers in North America, with lines such as Classic, Modern Steel, Coachman and Canyon Ridge. The model is usually printed on a label on the door's end stile, which helps us match replacement panels.

Typical $300-$900

Amarr Weather Seal Replacement

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $100-$300

Garaga Torsion Spring Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $200-$450

Wayne Dalton Garage Door Panel Replacement

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $300-$900

Martin Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Martin Door Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Linear Garage Door Sensor Repair

Linear openers and remotes are now part of Nice North America. Linear's MegaCode remotes are common on older openers and gate systems.

Typical $100-$250

Amarr Torsion Spring Replacement

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $200-$450

Windsor Door Extension Spring Replacement

Side-mounted extension springs replaced in matched pairs, with safety cables installed.

Typical $150-$350

Chamberlain Garage Door Opener Installation

Chamberlain is the retail line of The Chamberlain Group, sold at home centers. It uses the same Security+ 2.0 remote technology and myQ app as LiftMaster, so many accessories work with both brands.

Typical $350-$800

Midland Garage Door Garage Door Installation

New steel, insulated, wood-look and carriage-style doors, measured and professionally installed.

Typical $1,200-$4,500

Garage door stuck, noisy or broken?

Talk to a garage door technician in Connecticut now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote